SCALE X

Pages SCALE_1 … SCALE_8 (PageID 10 … 17). The ID column is the parameter_id you pass in a GET_PARAMETER request.

ID	Parameter name	TYPE	Read	Write	Default value	Description
0	SCALE_PARAMETER_COUNT	Uint32			0	Number of parameters on this page
7	MULTIRANGE_MAXIMUM_WEIGHTS	Float32 array			0	Scale capacity per range. Calculated from divisions × intervals
13	TEST_MODE_10X_RESOLUTION	Bool			False	Show the weight at ten times the resolution, for service use
18	ZERO_OFFSET	Float32			0	Current zero offset
49	EVENT_COUNTER_WEIGHT_OVERLOAD	Uint32			0	Counter of scale overloaded
57	CAL_PROGRESS_BAR	Uint32			0	Progress of a running calibration
58	TILT_ANGLE_X	Float32			0	Current tilt angle in X direction in degrees
59	TILT_ANGLE_Y	Float32			0	Current tilt angle in Y direction in degrees
61	LOAD_CENTER_POINT_X	Float32			0	Current load center point on X axis
62	LOAD_CENTER_POINT_Y	Float32			0	Current load center point on Y axis
63	WIM_COMPLETION_TIMEOUT	Uint32				How long a weigh-in-motion measurement may take before it is abandoned
64	ENABLE_LEVEL_ERROR	Bool			True	Enable level error when scale is tilting over 3 degrees
65	ZERO_SETTING_RANGE_PERCENTAGE	Float32				How far from zero SET_ZERO is still accepted, in % of capacity
67	FORK_LENGTH_MM	Uint32				Fork length in mm, used for the load centre calculation
69	LOAD_CENTER_THRESHOLD	Float32				How far off centre a load may sit before the weight is refused
70	TARE_PRESET_INDEX	Uint32			0	Index of the tare preset currently applied. 0 is the manual tare
71	TARE_PRESET_NAMES	String array				Names of the stored tare presets
72	TARE_PRESET_VALUES	Float32 array				Weights of the stored tare presets

Note

The tare preset list is read-only through the parameter system. Manage it with the CREATE_TARE_PRESET / UPDATE_TARE_PRESET / DELETE_TARE_PRESET requests, and apply an entry with SET_PRESET_TARE.